全自动脱水空气能烘干机 河北全自动脱水空气能烘干机 全自动脱
Principle of drying room:
The drying room uses the reverse Carnot principle to absorb the heat of the air and transfer it to the room, so as to increase the temperature and lower the humidity of the drying room, and cooperate with the high temperature and high humidity axial fan to achieve the drying of materials. Compressor, heat exchanger (internal machine), throttle, heat absorber (outer machine), compressor and other devices constitute a circulating system that circulates inside. It completes the gaseous pressure increase and temperature rise process in the compressor, enters the internal machine and releases high-temperature heat to heat the air in the drying room. At the same time, it is cooled and transformed into a liquid liquid. When it runs to the external machine, the liquid quickly absorbs heat and evaporates again. It is transformed into a gaseous state, and the temperature drops to minus 20℃～30℃. At this time, the air around the heat absorber will continuously transfer heat to the refrigerant. The refrigerant continuously circulates to carry the heat in the air to the drying room to heat the air temperature in the room.
The drying room is an equipment that transports heat:
Total heat transferred = input electric energy (compressor power) + heat transferred from air; the average annual energy efficiency ratio of air energy high-temperature drying rooms exceeds 300%. The average annual energy efficiency ratio of air energy heat pump dehumidification dryers exceeds 350. The average annual energy efficiency ratio of air energy heat pump drying cold storage units exceeds 600%.
drying room advantages:
1. Increase output: Compared with the traditional drying method, the heat pump drying equipment has a shorter drying period, an increase in drying capacity and a significant increase in output.
2. Energy saving: The operating cost is 1/3 of gas and oil-fired boilers. It is 1/4 of electric heating pipes. 3/4 of coal-fired boilers. Super saving money.
3. Environmental protection: Operation without waste heat, waste water, exhaust gas, etc., is green and environmentally friendly.
4. Reliable: no dangers such as inflammable and explosive (gas, oil), poisoning (coal burning), short circuit leakage, fire (electric heating), etc. No noise.
5. Fully automatic operation: Intelligent automatic operation, no personnel on duty, simple and convenient operation.
6. Not affected by the weather environment: Spring, summer, autumn and winter, wind and rain can be used normally.
7. Clean and sanitary: The materials are dried in a closed cycle in the drying room, free from external pollution.
8. The drying effect is good and fast: faster than traditional drying methods, save time and labor, greatly save costs, and have good drying quality.
1. The heating source has steam, electricity, far infrared, gas and electricity for users to choose
2. Use temperature: steam heating 50-130℃, high 140℃
3. Electricity, far-infrared temperature 50-300℃, can be equipped with automatic control system or computer control system for users to choose
Four, the usual steam pressure 0.2-0.8mpa (2-8kg/cm2)
5. Equipped with electric heating, 15kw calculated according to type 1. practical 5-8kw/h
VI. Special requirements shall be indicated when ordering
Seven, non-standard oven prices are negotiable
8. The operating temperature is greater than 140°C or less than 60°C, please specify when ordering
Nine, the drying car manufactured by our factory, the size of the baking pan is uniform and can be interchanged
X. Baking tray size: 460X640X45mm, can be matched with net tray, flat tray, aluminum tray, punching tray
四，通常的蒸汽压力0.2-0.8mpa（2-8kg / cm2）
5.配备电加热，按类型1计算15kw，实用5-8kw / h